Figure 26. Installing a cooling fan
NOTE: The images shown here are for representation only and the actual conguration of your system may vary.
2 Slide the cooling fan into the cooling fan assembly until the release tab locks into place.
Next steps
1 Install the air shroud.
2 Follow the procedure listed in After working inside your system.
Identifier GUID-BCD22C6D-D962-4630-ADD1-54CD6A01AC6F
Status Released
Intrusion switch
The chassis intrusion detection switch detects any intrusion into the system and creates a log entry in the system event log (SEL). This
switch is activated when the cover of your system is removed.
This section contains information about the removal and installation of the intrusion switch.
Identifier GUID-A316735D-08AA-458F-A6BF-ABF23638D8C5
Status Released
Removing an intrusion switch
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the cooling fan assembly.
Step
Press the intrusion switch and slide it out of the intrusion switch slot.
78
Installing and removing system components
To Next Page
Loading...
