Dell EMC NX3240 - Removing a 2.5-Inch Drive from the 3.5-Inch Drive Adapter

Figure 40. Installing a drive carrier
Next step
If applicable, install the front bezel.
Identifier GUID-CBC2DFCF-3F32-4FB3-AF60-85359DFA258C
Status Released
Removing a 2.5-inch drive from the 3.5-inch drive adapter
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove 3.5-inch drive adapter from the 3.5-inch drive carrier.
NOTE
: A 2.5-inch hot swappable drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch hot
swappable drive carrier.
Steps
1 Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
2 Remove the drive from the 3.5-inch drive adapter.
92
Installing and removing system components