Figure 44. Installing a 3.5-inch adapter into a 3.5-inch drive carrier
Next steps
1 Install the 3.5-inch drive carrier into the system.
2 Follow the procedure listed in After working inside your system.
Identifier GUID-F8EDF8B3-5E43-4250-AADD-27DF256D201D
Status Released
Removing a drive from the drive carrier
Prerequisite
Follow the safety guidelines listed in Safety instructions.
CAUTION
: Mixing drives from previous generations of NAS systems is not supported.
Steps
1 Using Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2 Lift the drive out of the drive carrier.
96
Installing and removing system components
To Next Page
Loading...
