Figure 51. Installing an expansion card
Next steps
1 Install the expansion card riser assembly.
2 Follow the procedure listed in After working inside your enclosure.
Removing the riser card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your enclosure.
3 Remove the expansion card riser assembly.
4 If installed, remove the expansion card.
Steps
1 Using the Phillips #2 screwdriver, remove the screws that secure the riser card to the expansion card bracket.
2 Lift the riser card away from the expansion card bracket.
104
Installing and removing enclosure components
To Next Page
Loading...
