Figure 53. Installing the riser card
Next steps
1 If removed, install the expansion card.
2 Install the expansion card riser assembly.
3 Follow the procedure listed in After working inside your enclosure.
Removing the M.2 SATA x16 riser
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your enclosure.
Steps
1 Using the Phillips #1 screwdriver, loosen the screw that secures the riser to the sled.
2 Lift the riser up to disengage the riser from the connector on the system board.
3 Disconnect the data cable from the riser.
106
Installing and removing enclosure components
To Next Page
Loading...
