Figure 55. Installing the M.2 SATA x16 riser
Next step
1 Follow the procedure listed in After working inside your enclosure.
Removing the M.2 SATA card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your enclosure.
3 If applicable, remove the expansion card riser assembly.
4 Remove the M.2 x16 riser or install the M.2 SATA x8 mezzanine card.
NOTE
: The procedure to remove the M.2 SATA x8 mezzanine card is similar to removing a mezzanine card.
Steps
1 Using the Phillips #1 screwdriver, unscrew the screw that secures the M.2 card to the board.
2 Pull the card out of the connector and lift the card away.
108
Installing and removing enclosure components
To Next Page
Loading...
