Steps
1 Attach and secure the mezzanine card bracket to the mezzanine card.
2 Holding the card by its edges, position the card so that the card edge connector aligns with the connector of the bridge board on the
system board.
3 Insert the card edge connector and push the card rmly until the card is fully seated on the bridge board.
4 Using the Phillips #2 screwdriver, secure the mezzanine card and bracket assembly to the sled using screws.
Figure 67. Installing a mezzanine card
Next steps
1 Install the mezzanine card or install the mezzanine card ller bracket.
2 Install the expansion card riser assembly
3 Follow the procedure listed in After working inside your enclosure.
Installing and removing enclosure components
117
To Next Page
Loading...
