Figure 69. Installing the mezzanine card bridge board
Next steps
1 Install the mezzanine card.
2 Install the expansion card riser assembly.
3 Follow the procedure listed in After working inside your enclosure.
Removing the OCP card
Prerequisites
NOTE
: The procedure to remove the mezzanine blank is similar to the removal of a mezzanine card.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your enclosure.
3 Remove the mezzanine card.
Steps
1 Push the blue retention clips away on one side and release the Open Compute Project (OCP) card.
Repeat step 1 to release the card from the clips on the other side.
2 Slide the card toward the front of the sled to disengage the connectors from the chassis and lift the card up.
Installing and removing enclosure components
119
To Next Page
Loading...
