Dell EMC PowerEdge C6420 - System Battery; Replacing System Battery

Figure 71. Installing the OCP card
Next steps
1 Install the mezzanine card.
2 Follow the procedure listed in After working inside your enclosure.
System battery
Replacing system battery
Prerequisites
WARNING
: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
NOTE: Battery is a Field Replaceable Unit (FRU). Only Dell certied service technicians must remove or install system battery.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your enclosure.
3 Remove the expansion card riser assembly.
Steps
1 Locate the battery socket. For more information, see the System board connectors section.
2 Insert a plastic scribe at the negative side of the battery connector and lever the battery up, lift the battery out of the socket.
Installing and removing enclosure components
121