CAUTION: Do not lift the system board by holding a memory module slot, any other connector, or component.
2 Hold the system board by the edges, and lift the system board away from the sled.
Figure 74. Removing the system board
Next step
1 Install the system board.
Installing system board
Prerequisite
Follow the safety guidelines listed in Safety instructions
CAUTION
: To avoid damage to the system board, ensure that the system board does not touch the side walls of the sled chassis,
while sliding the system board into the sled.
Steps
1 Holding the system board by the edges, slide the system board into the sled.
2 Install the screws that secure the system board to the sled.
124
Installing and removing enclosure components
To Next Page
Loading...
