Dell EMC PowerEdge C6420 - Maximum Vibration Specifications; Maximum Shock Specifications; Maximum Altitude Specifications; Fresh Air Operation

Gaseous contamination Specications
NOTE: Maximum corrosive contaminant levels measured at ≤50% relative humidity.
Maximum vibration specications
Table 24. Maximum vibration specications
Maximum vibration Specications
Operating 0.26 Grms at 5 Hz to 350 Hz (all operation orientations).
Storage 1.88 Grms at 10 Hz to 500 Hz for 15 min (all six sides tested).
Maximum shock specications
Table 25. Maximum shock specications
Maximum shock Specications
Operating 24 executed shock pulses 6 G in the positive and negative x, y, z
axis for up to 11 ms (four pulses on each side of the system).
Storage Six consecutively executed shock pulses of 71 G in the positive and
negative x, y, z axes for up to 2 ms (one pulse on each side of the
system).
Maximum altitude specications
Table 26. Maximum altitude
specications
Maximum altitude Specications
Operating 3048 m (10,000 ft)
Storage 12,000 m (39,370 ft)
Fresh Air Operation
Fresh Air operation restrictions
• Processors with a TDP greater than 105 W are not supported
• Support for processors of 85 W and below without PERC restrictions
• 3.5-inch drive conguration is not supported
• 114-mm heat sink is required for the processor in CPU1 socket
• Kerby-at OCP is not supported
36
Technical specications