Dell EMC PowerEdge C6420 - Air Shroud; Removing the Air Shroud

Figure 20. Installing the PERC battery
Next steps
1 If disconnected, connect the battery cable to the PERC card.
2 Follow the procedure listed in After working inside your enclosure.
Air shroud
Removing the air shroud
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your enclosure.
3 If applicable, disconnect the battery cable from the PERC card.
Steps
1 Press the clip on the air shroud to release the shroud from the sled.
2 Remove the shroud by rotating the shroud and releasing the hinge from the slot on the system.
Installing and removing enclosure components
71