Dell EMC PowerEdge C6420 - Support Bracket; Removing the Support Bracket

NOTE: The memory module socket has an alignment key that enables you to install the memory module in the socket in
only one orientation.
4 Press the memory module with your thumbs until the socket levers rmly click into place.
Figure 25. Installing a memory module
Next steps
1 Install the air shroud.
2 Follow the procedure listed in After working inside your enclosure.
3 To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System BIOS >
Memory Settings. In the Memory Settings screen, the System Memory Size must reect the updated capacity of the installed
memory.
4 If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is rmly
seated in the memory module socket.
5 Run the system memory test in system diagnostics.
Support bracket
Removing the support bracket
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your enclosure.
Step
Using the Phillips #1 screwdriver, remove the screws that secure the support bracket and lift the bracket away from the sled.
78
Installing and removing enclosure components