Dell EMC PowerEdge C6420 - Linking Board and Pcie Cable; Removing the Linking Board and Pcie Cables

Figure 27. Installing the support bracket
Next steps
1 Install the sled into the enclosure.
2 Follow the procedure listed in After working inside your enclosure.
Linking board and PCIe cable
Removing the linking board and PCIe cables
Prerequisites
NOTE
: Observe the routing of the cable as you remove it from the sled. Route the cable properly when you replace it to prevent
the cable from being pinched or crimped.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your enclosure.
3 Remove the air shroud.
4 Remove the support bracket.
Steps
1 Press the release clip on the PCIe_A cable connector to disconnect the cable. See the System board connector for more information.
2 Press the release clip on the PCIe_B cable connector to disconnect the cable. See the System board connector for more information.
3 If connected, disconnect the SATA cable from the x16 M.2 riser.
4 Using the Phillips #1 screwdriver, loosen the captive screws on the linking board and lift the board up along with the cables.
80
Installing and removing enclosure components