Dell EMC PowerEdge C6420 - Installing the Fabric Processor into the Processor Heat Sink Module

Figure 33. Removing the processor bracket
Next step
1 Install the fabric processor into the processor heat sink module.
Installing the fabric processor into the processor heat sink
module
Prerequisite
NOTE
: In a sled which has been congured with mixed CPUs – a fabric processor installed in the CPU2 socket and a non-fabric
processor installed in the CPU1 socket, you must connect the external Omnipath link cables to Port 2 on the OCP carrier card.
Follow the safety guidelines listed in Safety instructions.
Steps
1 Ensure that the processor is in the CPU tray.
NOTE
: Ensure that pin 1 indicator on the CPU tray is aligned with the pin 1 indicator on the processor.
2 Flex the outer edges of the bracket around the processor, close to the fabric connector, ensuring that the processor is locked into the
clips on the bracket.
3 Press the other end of the bracket to ensure that the clip is locked on to the processor.
NOTE
: Ensure that the pin 1 indicator on the bracket is aligned with the pin 1 indicator on the processor before placing
the bracket on the processor.
Installing and removing enclosure components 87