NOTE: Route the fabric cable for CPU2 under the heat sink of CPU1.
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the notches on the fabric connector with the guide pins on the processor base plate.
2 Push the connector toward the processor, until the connector is engaged with the edge connector on the processor.
3 Push the locking bar down to secure the fabric connector in place.
4 Insert the side band cable into the respective connector, and press down to lock the connector.
Figure 45. Installing the fabric and sideband cables
Next steps
1 Install the air shroud.
2 Follow the procedure listed in After working inside your enclosure.
Expansion cards
NOTE
: A missing or an unsupported expansion card riser logs an System Event Log (SEL) event. This does not prevent your
system from powering on and no BIOS, POST messages or F1 or F2 pause is displayed.
96 Installing and removing enclosure components
To Next Page
Loading...
