Dell EMC PowerEdge C6420 - Removing the Expansion Card Riser Assembly

Card type Form factor Link
width
Slot
priority
Maximum number of cards
Intel 70-W FPGA card LP x16 4 1
PM1725B 1.6 HHHL NVME card LP x8 4 1
PM1725B 3.2 HHHL NVME card LP x8 4 1
PM1725B 6.4 HHHL NVME card LP x8 4 1
P4800X 750GB HHHL PCIE card LP x8 4 1
Removing the expansion card riser assembly
Prerequisites
NOTE: Install an expansion card ller bracket over an empty expansion slot to maintain Federal Communications Commission
(FCC) certication of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airow
inside the system.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your enclosure.
Steps
1 Remove the screws that secure the expansion card riser assembly.
2 Lift the expansion card riser assembly out of the sled.
Figure 46. Removing the expansion card riser assembly
Next step
1 Install the expansion card riser assembly.
Installing and removing enclosure components
99