Figure 19 shows all the PowerEdge MX networking IOMs in the MCM group. The REST
API endpoint is used for switch life cycle management from the OME-M console in Full
Switch mode, and most configuration operations for SmartFabric Services mode. Some
administrative tasks include:
• View IOM-specific alerts
• Power cycle the IOM
• Configure or change device management information
• Configure supported breakout port modes
• Configure port administrative states
• Configure MTU
• Toggle Auto Negotiation
• Update IOM firmware
Figure 19. OME-M console – I/O Modules inventory
Figure 20 shows using the OME-M console to change the Breakout Type for port-
group1/1/1 on the IOM-A1, a MX9116n FSE. This behavior is similar for the MX5108n.
To Next Page
Loading...