Dell EMC PowerEdge MX7000 - Cabling for Dual MX7000 Configuration

Figure 18. Single PowerEdge MX7000 enclosure conguration
Cabling for a dual MX7000 enclosure conguration
The following gure shows the external cabling for a multiple PowerEdge MX7000 enclosure conguration. The Customer Network Link
Aggregation is shown as an example as the upper layer connection is not specied except that it must use an LACP enabled Link
Aggregation (LAG). You can add more enclosures that connect back to the upper level devices in the infrastructure.
26
Physical layout