Dell EMC PowerEdge MX7000 - Verify VLTi (Port-Channel); Configure Uplink LACP

VLT Peer Unit ID System MAC Address Status IP Address Version
----------------------------------------------------------------------------------
1 20:04:0f:0d:38:56 up fda5:74c8:b79e:1::1 1.0
MX7K-IOM-A2#
Verify the VLTi (port-channel)
To view the port channel summary, enter the following command:
MX7K-IOM-A1# show port-channel summary
Flags: D - Down I - member up but inactive P - member up and active
U - Up (port-channel)
--------------------------------------------------------------------------------
Group Port-Channel Type Protocol Member Ports
--------------------------------------------------------------------------------
1000 port-channel1000 (U) Eth STATIC 1/1/9(P) 1/1/10:1(P)
Congure the uplink Link Aggregation Control
Protocol
After the VLT is enabled, create the uplink to the network layer above the PowerEdge MX7000 enclosure. The connection should be an
Link Aggregation Control Protocol (LACP) active link aggregation of two ports. The MX5108n switches support uplink speeds of 100 GbE,
40 GbE, or 25 GbE on Ethernet port 1/1/11. In this example, the upstream ports are operating at 100 GbE so the breakout mode for the
interface is found in the running-conguration and should be:
interface breakout 1/1/11 map 100g-1x
If the running-conguration shows that the port is mapped to 10g or 40g, you can remap it by running the following command:
MX7K-IOM-A2#
MX7K-IOM-A2# configure terminal
MX7K-IOM-A2(config)# interface breakout 1/1/11 map 100g-1x
MX7K-IOM-A2(config)#
A VLT link aggregation is created by creating a VLT port-channel on each of the MX5108n switches. First create the uplink VLT port-
channel on both MX5108n switches.
MX7K-IOM-A2(config)#interface port-channel 1
MX7K-IOM-A2(config-if-po-1)# switchport mode trunk
MX7K-IOM-A2(config-if-po-1)# switchport trunk allowed vlan 1611-1614,2711-2712
MX7K-IOM-A2(config-if-po-1)# mtu 9216
MX7K-IOM-A2(config-if-po-1)# vlt-port-channel 1
MX7K-IOM-A2(config-if-po-1)# description VLT-uplink
MX7K-IOM-A2(config-if-po-1)# exit
Now add port 'ethernet 1/1/11' into port-channel 1.
MX7K-IOM-A2(config)#
MX7K-IOM-A2# configure terminal
MX7K-IOM-A2(config)# interface ethernet 1/1/11
MX7K-IOM-A2(config-if-eth1/1/11)# no shutdown
MX7K-IOM-A2(config-if-eth1/1/11)# no switchport
MX7K-IOM-A2(config-if-eth1/1/11)# mtu 9216
MX7K-IOM-A2(config-if-eth1/1/11)# channel-group 1 mode active
MX7K-IOM-A2(config-if-eth1/1/11)# exit
MX7K-IOM-A2(config)#
Manual switch
conguration 49