Dell EMC PowerEdge MX7000 - Configure Jumbo Frames

5 In the Add Uplink window, complete the following steps:
a Enter the name in the Name box.
b Enter the description in the Description box.
c From the Uplink Type list, select Ethernet.
d Click Next.
e From the Switch Ports list, select the appropriate Ethernet ports:
1 Ethernet 1/1/11 from both MX5108n IOMs
2 Ethernet 1/1/41 and Ethernet 1/1/42 from both MX9116n IOMs
f From the Tagged Networks list, select all four Cloud Foundation VLANs.
g From the Untagged Network list, select any required untagged VLAN.
h Click Finish.
6 To verify the switch topology, from the Devices menu, click Fabric, and then perform the following steps:
a Click the fabric that was created.
b Click Topology.
The selected topology image is displayed as shown in the following gure:
Figure 34. Topology of the SmartFabric using MX9116n Fabric Switching Engine IOMs
SmartFabric creates the uplink object and the status for the fabric changes to OK.
Congure jumbo frames
About this task
Cloud Foundation requires jumbo frames on all links.
NOTE
: By default, SmartFabric does not congure the jumbo MTU (frame size) on switch ports.
To congure jumbo frames, set the MTU (frame size) using the following procedure:
Steps
1 From the Devices menu, click I/O Modules.
2 Select the IO Module.
3 From the IOM banner menu, click Hardware.
4 Click Port Information.
SmartFabric network
conguration 59