Dell EMC PowerEdge MX7000 - Server Templates; Create a Server Template; Associate Server Template with VLAN

5 Select ports Ethernet 1/1/1-Ethernet 1/1/8 and the uplink port channel.
6 Click Congure MTU and set MTU to 9216.
7 Click Finish.
Jumbo frames that are required for the Cloud Foundation are congured.
Server templates
A server template contains the parameters that are extracted from a server and allows the parameters to be quickly applied to multiple
compute sleds. First, create an empty template by copying one from any existing compute sled. Then, modify the template and then apply
it to new compute sleds as needed.
Create a server template
About this task
To create a server template, perform the following steps:
Steps
1 Open the OME-M console.
2 From the Conguration menu, click Deploy.
3 In the center pane, click Create Template, and then click From Reference Device.
4 In the Create Template window, complete the following steps:
a In the Template Name box, enter MX740c with Intel mezzanine.
b Optionally, enter the description in the Description box.
c Click Next.
d In the Device Selection pane, click Select Device.
e In the Select Devices window, select Sled-1 from Chassis-1, and then click Finish.
f From the Elements to Clone list, select the following options:
1 iDRAC
2 System
3 NIC
g Click Finish.
A job starts and the new server template is displayed on the list. When the job completes, the status is displayed as Completed
Successfully.
Next step
After the job completes, associate the VLANs created earlier with the template.
Associate server template with a VLAN
Prerequisite
Before the server template is associated with VLAN, a server template must be created. For more information on creating the server
template, see Create a server template.
About this task
To associate the server template with VLAN, perform the following steps:
Steps
1 In the Deploy pane, select the MX740c with Intel mezzanine server template, and then click Edit Network.
2 In the Edit Network window, perform the following steps:
a Optionally, from the Identity Pool list, select Ethernet ID Pool.
b From the Untagged Network list, select the VLAN previously created to be the untagged VLAN for both ports.
c From the Tagged Network list, select all of the tagged VLANs for both ports.
60
SmartFabric network conguration