Figure 42. ESXi web interface—Edit settings page
5 In the Edit Port Group window, enter the Management VLAN ID, and then click Save.
CAUTION
: Leaving the VLAN ID at default setting causes pre-deployment validation to fail during a later step.
6 In the Navigator pane, click Manage to set up the NTP.
7 In the right pane, click Time & Date.
8 Click Edit Settings and then select Use Network Time Protocol (enable NTP client).
9 From the NTP Service Startup Policy list, select Start and stop with host.
10 In the NTP Servers box, enter the NTP server IP addresses.
NOTE
: If multiple IP addresses are provided, separate the IP addresses with commas.
11 Click Save.
Deploy ESXi to cluster nodes
71
To Next Page
Loading...