Cluster and VMs
From the vCenter console, review the virtual machines created by CloudBuilder. You should see 11 VMs running with their Status indicating
Normal.
Figure 51. Cluster and VMs
vSAN
About this task
Review the vSAN Disk Groups in vCenter by performing the following steps:
Steps
1 On the Hosts and Clusters tab, select the management cluster.
2 On the Congure tab, click Disk Management.
In the Disk Groups section, you should see each of your hosts in the management cluster and the disk groups.
NOTE
: In this example, there are two disk groups on each server with three disks in each group.
Figure 52. vSAN Disk Groups
NSX Manager
About this task
To verify that NSX Manager has been installed, perform the following steps:
82
Post-install validation
To Next Page
Loading...