Figure 45. Installing the BBU into the BBU cage
Next step
1 Install the BBU module.
Control panel
The control panel allows you to manually control the inputs to the sled.
Removing the control panel
Prerequisites
1 Follow the safety guidelines listed in Safety Instructions.
2 Follow the procedure listed in Before working inside the sled.
3 Remove the drives.
4 Remove the drive cage.
Steps
1 Pull the blue strap to disconnect the control panel cable connected to the system board.
2 Using a Phillips #1 screwdriver, remove the screws that secure the control panel to the system.
3 Slide the control panel out of the system.
68
Installing and removing system components
To Next Page
Loading...
