Figure 61. Installing a vFlash card
Next step
1 Follow the procedure listed in After working inside your sled.
PERC card
Your system includes dedicated slots on the system board for PERC cards.
Removing the PERC card
Prerequisites
1 Follow the safety guidelines listed in Safety Instructions.
2 Follow the procedure listed in Before working inside the sled.
3 Disconnect the cable connected to the PERC card.
Steps
1 Pull the blue pull tag to raise the lever up on the PERC card.
NOTE
: For the H730P MX(non-RAID) card, pull the two blue pull tags to raise the lever up. Rest of the procedure to
remove the PERC card remains identical to HBA330 MX (non-RAID) card.
NOTE: The MX740c supports both HBA330 MX or H730P MX PERC card.
2 Holding the blue pull tag, lift the PERC card away from the system.
88
Installing and removing system components
To Next Page
Loading...
