Figure 67. Installing the IDSDM card
Next step
Follow the procedure listed in After working inside your sled.
Removing a MicroSD card
Prerequisites
1 Follow the safety guidelines listed in Safety Instructions.
2 Follow the procedure listed in Before working inside the sled.
3 Remove the IDSDM card.
Steps
1 Locate the MicroSD card slot on the IDSDM card.
NOTE
: To locate IDSDM slot on the system board, see the system board jumpers and connectors.
2 Press the card to partially release from the slot.
3 Hold the MicroSD card and remove it from the slot.
NOTE
: Temporarily label each MicroSD card with the corresponding slot number after removal.
94 Installing and removing system components
To Next Page
Loading...
