Figure 76. Installing the left control panel
Next step
1 Follow the procedure listed in the After working inside your system.
Removing the right control panel
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 If applicable, remove the front bezel.
4 Remove the air shroud.
Steps
1 Disconnect the control panel cable from the system board connector.
NOTE
: Ensure that you note the routing of the cables as you remove them from the system board.
2 Using the appropriate screwdriver, remove the screws that secure the right control panel assembly to the system.
3 Holding the control panel assembly, remove the control panel from the system.
Installing and removing system components
103
To Next Page
Loading...
