Figure 10. Installing the front bezel
System cover
Removing the system cover
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Disconnect the system from the electrical outlet and disconnect the peripherals.
3 If applicable, remove the system from the rack.
NOTE
: For more information, see the
Rail Installation Guide
at Dell.com/poweredgemanuals.
Steps
1 Using a 1/4 inch at head or a Phillips #2 screwdriver, turn the lock on the release-latch counterclockwise to the unlock position.
2 Open the release-latch until the system cover slides back.
3 Lift the cover away from the system.
42
Installing and removing system components
To Next Page
Loading...
