Figure 23. Removing the drive from the drive carrier
Installing the drive into the drive carrier
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 If installed, remove the front bezel.
3 Remove the drive blank.
Steps
1 Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2 Align the screw holes on the drive with the screws holes on the drive carrier.
3 Using a Phillips #1 screwdriver, replace the screws to secure the drive to the drive carrier.
NOTE
: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 inch-pounds.
NOTE: Use the screws shipped with the drive carrier to secure the drive to the drive carrier.
Installing and removing system components 53
To Next Page
Loading...
