Figure 28. Installing a 3.5-inch drive adapter into the 3.5-inch drive carrier
Next steps
1 Replace a 3.5-inch drive carrier.
2 Follow the procedure listed in After working inside your system.
Removing a cabled drive
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
CAUTION
: Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1 Disconnect the power and data cable connector that is connected to the drive.
2 Press the release button, and slide the drive out of the drive slot.
58
Installing and removing system components
To Next Page
Loading...
