Figure 30. Installing a cabled drive
Next step
1 Follow the procedure listed in the After working inside your system.
Removing the cabled drive from the drive carrier
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 Remove the front bezel.
4 Remove the drive.
CAUTION
: Mixing drive carriers from previous generations of PowerEdge servers is not supported.
CAUTION: To maintain proper system cooling, all empty drive slots must have drive carrier blanks installed.
Steps
1 Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2 Lift the drive out of the drive carrier.
60
Installing and removing system components
To Next Page
Loading...
