Figure 31. Removing the cabled drive from the drive carrier
Next step
1 Install the drive into the drive carrier.
Installing a cabled drive into the drive carrier
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 Remove the front bezel.
Steps
1 Insert the drive into the drive carrier with the connector end of the drive toward the back of the drive carrier.
2 Align the screw holes on the drive with the screw holes on the drive carrier. When aligned correctly, the back of the drive is ush with
the back of the drive carrier.
3 Install the screws to secure the drive to the drive carrier.
Installing and removing system components
61
To Next Page
Loading...
