Figure 33. Removing the intrusion switch
Next step
1 Replace the intrusion switch.
Installing the intrusion switch
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
Steps
1 Align and slide the intrusion switch into the slot in the system.
2 Route the intrusion switch cable through the cable routing clips.
3 Connect the intrusion switch cable connector to the connector on the system board.
Figure 34. Installing the intrusion switch
Next step
1 Follow the procedure listed in the After working inside your system.
System memory
Installing and removing system components
63
To Next Page
Loading...
