Dell EMC PowerEdge R240 - Installing the Expansion Card Riser

Figure 40. Installing the expansion card riser ller
Next step
1 If applicable, replace the expansion card riser.
Installing the expansion card riser
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 Remove the air shroud.
4 Install the expansion card in the expansion card riser.
Steps
1 If applicable, remove the expansion card riser ller bracket by performing the following steps:
a Open the blue expansion card retention latch lock.
b Using a Phillips #2 screwdriver, remove the screw securing the expansion card riser ller to the system board.
c Slide the expansion card riser ller bracket up and out of the system.
70
Installing and removing system components