Dell EMC PowerEdge R240 - Installing Expansion Card into the Expansion Card Riser

Figure 44. Installing the expansion card ller
Next step
1 Install the expansion card into the expansion card riser.
Installing expansion card into the expansion card riser
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 If installing a new expansion card, unpack it and prepare the card for installation.
NOTE
: For instructions, see the documentation accompanying the card.
4 Remove the air shroud.
5 Remove the expansion card riser.
Steps
1 Remove the ller bracket.
NOTE
: Store the ller bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certication of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airow inside the system.
Installing and removing system components 73