Dell EMC PowerEdge R240 - Optional Internal USB Memory Key

Figure 50. Installing system battery
Next steps
1 Install the expansion card riser.
2 Install the air shroud.
3 Follow the procedure listed in the After working inside your system.
4 Conrm that the battery is operating properly, by performing the following steps:
a Enter the System Setup, while booting, by pressing F2.
b Enter the correct time and date in the System Setup Time and Date elds.
c Exit the System Setup.
d To test the newly installed battery, remove the system from the enclosure for at least an hour.
e Reinstall the system into the enclosure after an hour.
f Enter the System Setup and if the time and date are still incorrect, see Getting help section.
Optional internal USB memory key
An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device. To boot from
the USB memory key, congure the USB memory key with a boot image and then specify the USB memory key in the boot sequence in
System Setup.
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE
: To locate the internal USB port on the system board, see the System board jumpers and connectors section.
78 Installing and removing system components