Dell EMC PowerEdge R240 - Replacing the Optional Internal USB Memory Key; Optional Optical Drive; Removing the Optional Optical Drive

Replacing the optional internal USB memory key
Prerequisites
CAUTION: To avoid interference with other components in the server, the maximum permissible dimensions of the USB memory
key: 15.9 mm width x 57.15 mm length x 7.9 mm height.
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 Remove the expansion card riser.
Steps
1 Locate the USB port or USB memory key on the system board.
To locate the USB port, see the System board jumpers and connectors section.
2 If installed, remove the USB memory key from the USB port.
3 Insert the replacement USB memory key into the USB port.
Next steps
1 Replace the expansion card riser.
2 Follow the procedure that is listed in After working inside your system.
3 While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Optional optical drive
Removing the optional optical drive
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 Remove the front bezel.
4 Remove the air shroud.
5 Disconnect the cables from the connectors on the optical drive.
NOTE
: Ensure that you note the routing of the power and data cable on the side of the system as you remove them from
the system board and drive.
Steps
1 Press the release tab to release the optical drive from the system.
2 Slide the optical drive out of the system until it is free of the optical drive slot.
3 If you are not installing a new optical drive, install the optical drive blank.
NOTE
: The procedure to install an optical blank is similar to the optical drive.
Installing and removing system components 79