Figure 51. Removing the optional optical drive
Next step
1 If applicable, replace the optical drive.
Installing the optional optical drive
Prerequisites
The procedure for installing an optical drive and optical drive blank.
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 Remove the front bezel.
4 Remove the air shroud.
5 If installed, remove the optical drive blank.
NOTE
: The procedure to remove the optical drive blank and the optical drive is similar.
Steps
1 Align and slide the optical drive into the slot until the release tab snaps into place.
2 Connect the power and data cables to the connectors on the optical drive.
NOTE
: Route the cables properly to prevent them from being pinched or crimped.
80 Installing and removing system components
To Next Page
Loading...
