Figure 57. Installing the optional IDSDM or vFlash card
Next steps
1 Install the MicroSD cards.
NOTE
: Reinstall the MicroSD cards into the same slots that are based on the labels you had marked on the cards during
removal.
2 Install the air shroud.
3 Follow the procedure that is listed in After working inside your system.
Removing the MicroSD card
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 Remove the air shroud.
4 Remove the IDSDM or vFlash module.
Steps
1 Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/
vFlash module, see the System board jumpers and connectors section.
2 Hold the MicroSD card and remove it from the slot.
NOTE
: Temporarily label each MicroSD card with its corresponding slot number after removal.
86 Installing and removing system components
To Next Page
Loading...
