Figure 58. Removing the MicroSD card
Next step
1 Replace the MicroSD cards.
Installing the MicroSD card
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 Remove the air shroud.
4 Remove the IDSDM or vFlash module.
NOTE
: To use a MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE: If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the
cards during removal.
Steps
1 Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot. To locate IDSDM/vFlash, see the System board jumpers and connectors section.
NOTE
: The slot is keyed to ensure correct insertion of the card.
2 Press the card into the card slot to lock it into place.
Installing and removing system components
87
To Next Page
Loading...
