f Internal Dual SD module, if installed
4 Disconnect all the cables that are connected to the system board.
CAUTION: Take care not to damage the system identication button while removing the system board from the system.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
Steps
1 Using a Phillips #2 screwdriver, remove the screws securing the system board to the chassis.
Figure 71. Screws securing the system board
2 Holding the system board holder, slightly lift the system board, and slide the system board to the front of the system.
3 Using the system board holder, lift the system board out of the system.
96
Installing and removing system components
To Next Page
Loading...
