• LTO-6 SAS
• LTO-7 SAS
• LTO-8 SAS
Internal Dual SD Module
The Internal Dual SD Module (IDSDM) is optional. The IDSDM contains two SD ports directly on the motherboard. The modules are
redundant. Supported iDSDM microSD cards capacity are 8/16/32/64GB
The IDSDM card provides the following functions:
• Dual SD interface is maintained in a mirrored conguration (primary and secondary SD)
• Provides full RAID1 functionality
• Dual SD cards are not required; the module can operate with only one card but will provide no redundancy
• Enables support for Secure Digital eXtended Capacity (SDXC) cards
• USB interface to host system
• I2C interface to host system and onboard EEPROM for out-of-band status reporting
• Onboard LEDs show status of each SD card
• A BIOS Setup Redundancy setting supports Mirror Mode or Disabled
Boot Optimized Storage Subsystem (BOSS)
BOSS is oered as a means of booting the PowerEdge R340 servers to a full OS when:
• A solution such as IDSDM may be desired, but the target OS for BOSS is a full OS (not just a hypervisor)
• The user needs to maximize their number of drive bays
BOSS cards take up a PCIe slot and are not hot-plug capable. 1x or 2x 240GB modules are available. Dual (2x) module congs can be
set up for either RAID 1 or No RAID. Single (1x) module congs can only be set up in a No RAID cong.
20