Figure 17. Removing the air shroud
Next steps
1. Replace the air shroud.
Installing the air shroud
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Align the slot on the air shroud with the standoff on the chassis.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Lower the air shroud into the system until it is firmly seated.
Figure 18. Installing the air shroud
Next steps
1. Follow the procedure listed in After working inside your system.
PowerEdge R340 installing and removing system components
43
To Next Page
Loading...
