Dell EMC PowerEdge R340 - Removing an Expansion Card from the Expansion Card Riser

Figure 39. Removing the expansion card riser filler
2. Align the guide on the expansion card riser with the guide pin on the chassis.
3. Lower the expansion card riser until the expansion card riser is firmly seated in the slot.
4. Close the expansion card riser latch.
Figure 40. Installing the expansion card riser
Next steps
1. Follow the procedure listed in the After working inside your system.
Removing an expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Disconnect any cables that are connected to the expansion card or expansion card riser.
4. Remove the expansion card riser.
62
PowerEdge R340 installing and removing system components