Figure 107. Installing the system board
Next steps
1 Replace the following:
a Trusted Platform Module (TPM)
b Internal PERC riser
c Internal USB key (if applicable)
d USB 3.0 module (if applicable)
e IDSDM/vFlash module card
f All expansion cards and risers
g Processors and heat sink modules
h Processors blanks (if applicable)
i Memory modules and memory module blanks
j LOM riser card
k Air shroud
2 Reconnect all cables to the system board.
NOTE
: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3 Follow the procedure listed in After working inside your system.
4 Ensure that you:
a Use the Easy Restore feature to restore the Service Tag. For more information, see the Restoring the Service Tag by using the
Easy Restore feature section.
b If the Service Tag is not backed up in the backup ash device, enter the Service Tag manually. For more information, see the
Restoring the Service Tag by using the Easy Restore feature section.
c Update the BIOS and iDRAC versions.
d Re-enable the Trusted Platform Module (TPM). For more information, see the Upgrading the Trusted Platform Module section.
5 Import your new or existing iDRAC Enterprise license.
For more information, see iDRAC User's Guide, at Dell.com/idracmanuals.
Installing and removing system components
143
To Next Page
Loading...
