Dell EMC PowerEdge R540 - Installing the Internal PERC Riser

3 Installing the internal PERC riser
Installing the internal PERC riser
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Connect the cable to the internal PERC card.
Figure 39. Connecting the cable to internal PERC riser
2 Holding the blue touch points, align the slot on the internal PERC riser to the guide on the system board.
3 Insert the internal riser card’s edge connector rmly into the system board connector until the riser is fully seated.
4 Lift the plunger to lock the riser in place.
86
Installing and removing system components