Dell EMC PowerEdge R540 - Removing a 3.5-Inch Drive Adapter from a 3.5-Inch Drive Carrier

Figure 48. Installing a 2.5-inch drive into a 3.5-inch drive adapter
Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 If installed, Removing the front bezel
3 Remove the 3.5-inch drive carrier from the system.
Steps
1 Using a Phillips #1 screwdriver, remove the screws from the rails on the drive carrier.
2 Lift the 3.5 inch drive adapter out of the 3.5-inch drive carrier.
94
Installing and removing system components