Option Description
Select Simple to display LCD error messages in a simplied user-friendly description. See the Dell Event and Error
Messages Reference Guide at dell.com/esmmanuals for the list of messages in this format.
Set home Select the default information to be displayed on the LCD Home screen. See View Menu to see the options and
option items that can be set as the default on the Home screen.
View menu
NOTE: When you select an option in the View menu, you must conrm the option before proceeding to the next action.
Option Description
iDRAC IP Displays the IPv4 or IPv6 addresses for the iDRAC7. Addresses include DNS (Primary and Secondary), Gateway,
IP, and Subnet (IPv6 does not have Subnet).
MAC Displays the MAC addresses for iDRAC, iSCSI, or Network devices.
Name Displays the name of the Host, Model, or User String for the system
Number Displays the Asset tag or the Service tag for the system.
Power Displays the power output of the system in BTU/hr or Watts. The display format can be congured in the Set
home submenu of the Setup menu.
Temperature Displays the temperature of the system in Celsius or Fahrenheit. The display format can be congured in the Set
home submenu of the Setup menu.
Conguring iDRAC from the LCD panel
The LCD panel on the front bezel (optional) has these three buttons for selecting, changing, and entering data:
• ✓ = Enter
• < = Move the selection to the left or decrease the value (depending on the context)
• > = Move the selection to the right or increase the value (depending on the context)
We can assign iDRAC IP address by using LifeCycle controller, BIOS, and from the LCD panel.
NOTE
: Changing iDRAC IP from the LCD panel will only be available on system with optional front bezel with LCD panel.
1 Press ✓ to enter the system menu.
2 Press > to select Setup and then press ✓.
3 Select iDRAC, and press ✓.
4 Press > to select StaticIP and press ✓.
NOTE
: The LCD panel might display a default IP address. You need to change the numbers that dier from the static IP
address you want to assign.
5 Press > until you have selected a number that you want to change and then press ✓ to set the number.
6 Press > to increase the value or < to decrease the value. When the correct number is displayed, press ✓.
7 Repeat steps 5 and 6 for each additional number you need to change.
8 When the static IP address is correct, press > until » is selected, and then press ✓.
9 The LCD shows the default subnet mask (Sub). Use the instructions in steps 5 and 6 to modify values as needed.
10 Press > until » is selected, and then press ✓.
11 The LCD shows the default gateway IP address. Use the instructions in steps 5 and 6 to modify values as needed.
About your system
11
To Next Page
Loading...
