Option Description
CCX as NUMA Domain Enables or disables the CCX as NUMA Domain. This option is set to
Disabled by default.
Minimum SEV-ES ASID Determines the number of Secure Encrypted Virtualization ES and
non ES available Address Space IDs. This option is set to 1 by
default.
x2APIC Mode Enable or disable x2APIC mode. This option is set to Enabled by
default.
Number of CCDs per Processor Controls the number of enabled CCDs in each processor. This
option is set to All by default.
Number of Cores per CCD specifies the number of cores per CCD. This option is set to All by
default.
Processor Core Speed Specifies the maximum core frequency of the processor.
Processor n
NOTE: Depending on the number of CPUs, there might
be up to n processors listed.
The following settings are displayed for each processor installed in
the
system:
Table 16. Processor n details
Option Description
Family-Model-Stepping Specifies the family, model, and stepping of the processor as
defined by AMD.
Brand Specifies the brand name.
Level 2 Cache Specifies the total L2 cache.
Level 3 Cache Specifies the total L3 cache.
Number of Cores Specifies the number of cores per processor.
Microcode Specifies the processor microcode version.
SATA Settings
To view the SATA Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS > SATA
Settings.
Table 17.
SATA Settings details
Option Description
Embedded SATA Enables the embedded SATA option to be set to Off, AHCI mode , or RAID modes. This
option is set to AHCI Mode by default.
NOTE:
1. You might also need to change the Boot Mode setting to UEFI. Otherwise,
you should set the field to Non-RAID mode.
2. No ESXi and Ubuntu OS support under RAID mode.
Security Freeze Lock Sends Security Freeze Lock command to the embedded SATA drives during POST. This
option is applicable only for AHCI Mode. This option is set to Enabled by default.
Write Cache Enables or disables the command for the embedded SATA drives during POST. This option is
set to Disabled by default.
Port n Sets the drive type of the selected device.
For AHCI Mode or RAID Mode, BIOS support is always enabled.
Pre-operating system management applications 27
To Next Page
Loading...
